CAA Québec

Blog (Heading)

Reset drum (photoconductor) Dell

Reset drum (photoconductor) Dell

How to reset the photoconductor counter

Read comments | Leave your comment |


Instructions

  1. Resetting the Drum Page Counter

    • 1
      Toggle switch in back of the printer.

      Shut off the printer.

    • 2
      Front door opened

      Hold down the "Cancel" button while opening the front door. Then turn on the printer

    • 3
      Error LED lit

      Keep the Continue button held down until only the "Error LED" is on then release the button. Close the door.

    • 4
      Top 3 LEDs lit.

      The Continue button, Ready/Data, Toner Low, and Load Paper LEDs should all be lit up.

    • 5
      Toner low LED lit.

      Press "Cancel" a few times to cycle through the LEDs until just the "Toner Low LED" is lit.

    • 6

      Press and hold the "Continue" button until the LEDs cycle through and release only when the LED stops at Toner Low.

    • 7

      Turn the printer off and back on.


Read comments | Leave your comment |


 Source of information: Service support, Dell & SCC & Uninet & Summit

Related Comments

Leave your comment